|
|
 |
|
|
|
|
| |
 |
LAYING INSTRUCTIONS |
 |
|
|
| |
|
|
| |
Laying Varmora VITRIFIED TILES |
|
| |
|
|
| |
Plaster the surface of the floor to be laid with smooth finish and complete the plastering and curing at least one week prior to installation.
Kindly look for the arrow (  ) on the back of the tile and follow the laying pattern as shown in Visual (A) or Visual (B). |
|
| |
 |
Visual (A) |
Visual (B) |
|
|
|
| |
|
|
| |
Before fixing VARMORA Vitrified Tiles, lay them out in the desired pattern and make sure that they give an acceptable blend of colour. Please note that certain amount of shade variation is inherent in the manufacturing of a vitrified product.
For fixing VARMORA Vitrified Tiles, we recommend the use of chemical fixing adhesives available in the market with proper trowelling method for 100% coverage behind the tile and for peerless bonding. Please follow the fixing instructions provided along with the adhesives.
For fixing VARMORA Vitrified Tiles on the floor using sand and cement, follow the instructions given below: |
|
| |
| A) |
Use cement and sand mortar in the ratio of 1:4 Add some water to create a consistent paste. |
| B) |
Once the mixing is completed do not add any further water and use the same within one hour. |
| C) |
Apply a 20-30 mm. Layer of bedding material over an area of 1 square meter at a time on the surface of the area. Apply a fine slurry to the back of the tile to ensure proper and full-bedding. |
| D) |
Press gently for even adherence at the back of the tile. DO NOT USE AN IRON HAMMER OR SOME HEAVY MATERIAL TO PRESS THE TILE. |
|
|
| |
|
|
| |
For fixing VARMORA Vitrified Tiles on Dado, we recommend the use of chemical fixing adhesives available in the market. Please follow the manufacturers instructions for the same. We do not recommend the use of sand and cement for fixing on Dado.
Mark and lay out tiles from the center of the area to be layed so that the cut tiles, if any, will appear on the outer edge towards the wall.
The nominal size we maintain is 605 X 605 mm. As a part of the internationally accepted laying practices, use of 2 to 5 mm. Spacers is recommended.
Complete the tiles laying process by pressing the cut VARMORA Vitrified Tiles firmly into place along the floors. |
|
| |
|
|
| |
|
|
| |
|
|
| |
|
|
|
|
|
|
|
|
|
|
